Check hard disk for bad sectors, restore hdd

The main purpose of Disk Revival is the blocking of slow sectors on the HDD. But it can also check the hard drive for broken ones and restore them (though not always). The principle is very simple and original. Blocking files are written to the place of broken sectors (if the state of the surface allows). As a result, when a person starts using hdd, all data is recorded only in good areas, because the damaged ones are already occupied by locking files (they are placed in one folder and do not interfere with the user in any way). This of course is not the restoration of broken sites, they are not fixed and not cleaned, but this allows to achieve the effect, as if they were not there. Files do not beat, the disk runs faster, and what else do you need?

By running Disk Revival, you can check the hard disk (HDD) on the broken sectors. True verification can take a long time. I recommend using it if you already know that there are similar problems and you need to remove them.

How to check the hard drive for broken sectors and restore

Other ways to restore (remove, fix, cure)

The damaged sectors of hdd can not be restored by the program of course. This is a problem of physical degradation of the hdd surface. But there are ways to block them. All existing utilities use for this the Remap method ( Victoria for example). The problem is that it does not always work. The blocking method used in Disk Revival is also not ideal, but it often allows you to block sectors that can not be repaired. These methods complement each other. Ideally, I recommend Remap first, and then process it with my program. - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -